Door Thickness? Emtek Privacy Pocket Door Lock. Emtek Passage. Pocket Door Lock. Part Number Asked by Lynne on January 6, Answer: Yes, this includes a pull for the door edge. Answer provided by Marc on January 8, Asked by mike on December 1, Answer: Yes, the strike plate is supplied with this pocket door lock. Answer provided by Marc on December 4, Asked by Jeff on October 27, Answer: Yes, this product is reversible and handing is not required.
Answer provided by Marc on October 30, Asked by Paul Mallett on December 3, Answer provided by Marc on December 5, Asked by Elizabeth Scott on March 31, By Construct-Ed Leave a Comment.
Either read the article below, or watch the free video course to learn how. If you like a somewhat open concept and want to have open entry ways, but still want the ability to block off sound or shut a door to be able to have a meeting, conversation, or achieve some privacy, a pocket door is a great solution. Essentially, pocket doors are doors on sliders that hide away in the wall when not used.
This article will walk you through a 5 step process of how to install pocket door hardware: the actual handle and latch system that allows you to slide the door across the entryway. To watch the free, full video course- click here.
Step 1- Read the directions : Wherever you purchased your pocket door hardware, start by reading the directions that come with the door hardware that you purchased. Make sure that the hardware is for the thickness and the type of door that you are installing the hardware for, and take note of any warnings or special notes the manufacturer gives.
Typically, this involves measuring off of the floor, to the center of your door see below and make mark with your pencil. This is the exact center of where you want your door latch to be. Use the pilot hole to insert the jigsaw blade and cut along the pre-marked lines. If the door still does not operate smoothly, add some more spray until the operation is smooth. Another problem is that over time, the doors may become out of alignment will not close or lock properly.
Use a pocket door wrench to turn the hanger a quarter of a turn at a time until the door is parallel with the jamb. If you have a gap at the bottom of the door that is causing rubbing towards the top of your door, you can lower the door by adjusting the hanger that is positioned the furthest away from the door latch. New track and pocket door rollers Locate the screws holding the lock in place on the inside of the door.
Troubleshooting and repairing issues with pocket doors is. If the pocket door is hard to open and close, the door rollers may need to be lubricated. Move the door back and forth to work the lubricant into the nooks and crannies. Videos you watch may be added to the tv's watch history and influence tv recommendations. Instead, spray each roller once or twice with silicone spray.
If playback doesn't begin shortly, try restarting your device. You can use the flip out handle to. Latches and locksets that are sticking or making noise need lubrication. If the rollers will not free up, they may need to be replaced, see the article ' replacing pocket door rollers ' for more information.
Lubricating a pocket door lock. Again there is a method that needs to be followed to get the pocket door back on the track.
0コメント